Ownership · 1 October 2026 · 2 min read
What You Can Actually Do at Each Water-Resistance Rating
By The Royalzman Atelier
We have written about how water resistance is tested and why the number is a floor rather than a diving licence. This is the practical companion: what the common ratings actually permit in real life, where the figures mislead almost everyone.
The central confusion is that the ratings are stated in metres but are not swimming depths. They come from a static pressure test in a laboratory, and real water adds dynamic forces — the slap of a dive into a pool, the push of a swimming stroke — that briefly exceed the static figure. So the usable guidance is always more conservative than the printed number.
A watch marked 30 metres (3 bar) is splash-proof only: rain, hand-washing, a caught shower. Do not swim in it. At 50 metres (5 bar) you can swim and shower with care, but not dive or jump in. At 100 metres (10 bar) — the minimum a true diver's watch must meet — you can snorkel and swim freely. At 200 metres (20 bar) and above, with a screw-down crown, the watch is genuinely fit for recreational scuba diving.
Two caveats apply at every rating. Heat and sudden temperature change are hard on seals, so leave the watch off in hot showers, saunas and hot tubs regardless of the number. And never operate the crown or pushers underwater — and on a screw-down crown, always confirm it is fully screwed home before the watch goes near water.
Finally, remember that these ratings describe the watch when new. Gaskets age, and water resistance fades with them. The printed figure is a promise about the day the watch was tested, not a permanent property — which is why a periodic pressure test, covered in our care guide, is what keeps the number honest over the years.
More from the Journal