Ownership · 10 October 2026 · 2 min read
Caring for Your Dive Watch
By The Royalzman Atelier
A dive watch is made to be worn hard, but water resistance is not permanent. It depends on gaskets — small rubber seals at the crown, caseback and crystal — and rubber ages. Understanding that is the whole of good watch care.
Start with the simplest habit: after contact with salt water, chlorine or sand, rinse the watch under fresh, cool tap water and dry it with a soft cloth. Salt crystals and grit are what abrade seals and scratch the case over time. Thirty seconds under a tap does more for longevity than anything else you can do.
Always check that the crown is fully pushed in — and screwed down, if your model has a screw-down crown — before the watch goes near water. An open crown is the single most common cause of a flooded watch, and it has nothing to do with how well the watch was built.
Gaskets harden and shrink with heat, UV and time, typically within two to five years of regular wear. For a watch used often in water, a pressure test and fresh seals every eighteen months or so is sensible; for a watch that mostly sees showers and the occasional swim, every two to three years is plenty. The test is quick, and it is the only way to confirm the seals are still doing their job.
This is also why our warranty is written the way it is. Every Royalzman carries a three-year warranty covering manufacturing defects in materials and workmanship — the things that are ours to get right. It does not cover accidental damage, misuse, or water entry from worn gaskets after the first year, because seals are wear items that depend on servicing, not on how the watch was made.
Treated with this much care — a rinse, a glance at the crown, a service when it is due — a mechanical watch does not simply last. It becomes the kind of object you hand on. That is what it was built for.
More from the Journal