← The Journal

The Atelier · 6 October 2026 · 2 min read

The Steel Behind the Case

By The Royalzman Atelier

Most steel watch cases look alike across a shop window. The differences are in the metallurgy, and they reveal themselves slowly — in how a case ages after years against skin and salt water.

The industry workhorse is 316L stainless steel: a low-carbon, surgical-grade alloy that is tough, hypoallergenic and genuinely corrosion-resistant. The great majority of fine watches, including many at the top of the market, are made of it, and for good reason. It takes a crisp finish, resists rust well, and holds up to a lifetime of ordinary wear.

A smaller number of makers use 904L — a so-called superaustenitic steel with more chromium, nickel and molybdenum, plus a little copper. Its advantage is specific: superior resistance to pitting corrosion, the tiny salt-induced craters that can form in case threads and casebacks after long exposure to seawater and sweat. Rolex adopted it decades ago, branding it Oystersteel, precisely because dive watches were coming back from the sea with corroded threads. It also polishes to a slightly brighter, cooler shine — and it is considerably more expensive and harder to machine.

In honest daily use the gap is narrow. If you swam in salt water several times a week for fifteen years and never had the watch serviced, a 904L case would likely show less pitting than a 316L one. For almost everyone, well-finished 316L, rinsed after the sea and serviced on schedule, will outlive its owner without complaint.

Titanium is the third path: around 40 percent lighter than steel, highly corrosion-resistant, and warm against the skin, at the cost of being softer and more prone to scuffs unless specially hardened. The right answer is not a single alloy but a match between metal, purpose and price — and knowing which is in your case tells you something about how the watch was conceived.

More from the Journal

0%
The Steel Behind the Case — Royalzman