Horology · 4 October 2026 · 2 min read
Sapphire, Mineral, Acrylic: The Glass Over Your Dial
By The Royalzman Atelier
The crystal is the clear cover over the dial, and you interact with it more than any other part of the watch — every glance passes through it. Three materials dominate, and the choice between them is a quiet trade between scratch resistance, shatter resistance and cost.
Hardness is measured on the Mohs scale, where talc is 1 and diamond is 10. Acrylic — essentially a clear plastic — sits around 3. Mineral glass, a hardened silicate, lands near 5 to 6. Sapphire crystal, grown synthetically from aluminium oxide, reaches 9, bettered only by diamond. A material can be scratched only by something as hard or harder, which is why a sapphire crystal shrugs off keys, desk edges and grit that would quietly haze a softer one.
But hardness and toughness are not the same thing. Acrylic is almost impossible to shatter and can be polished at home to erase scratches — one reason it endured for decades and why vintage watches wear it with charm. Sapphire, for all its scratch resistance, is more brittle: a sharp, concentrated impact can chip or crack it where acrylic would merely dent. Mineral glass sits in the middle on both counts, a sensible and affordable compromise.
Sapphire has one optical quirk: it is more reflective than mineral glass because light bends more sharply passing through it. The remedy is anti-reflective coating, a microscopically thin layer applied to one or both faces that cuts glare dramatically. A well-coated sapphire crystal can seem to vanish, leaving the dial looking open to the air — and legibility, especially underwater or in bright sun, is exactly what a dive watch needs.
For a modern tool watch, sapphire with anti-reflective coating is the standard and the right one: it keeps a dial looking new for decades of hard wear. Knowing its one weakness — a hard point impact — is simply knowing not to strike it against stone, which is good advice for any watch.
More from the Journal